SS316L Horizontal Decanter Centrifuge For Paper Mill Sewage Treatment

Description

In a sewage plant, what is the process of using a spiral settling centrifuge for desliming?

In sewage treatment plant, in the treatment of activated sludge, the whole process of using spiral settling centrifuge is: through the high-speed rotating drum, to drive the high-speed rotation of sludge, and then generate centrifugal force, so that the solid particles in the sludge settlement is accelerated, and concentrated on the drum wall. Then, through the spiral, the mud cake is scraped to the small end of the drum, so that it can be discharged, thus completing the mud removal work.

What is the advantage of decanter centrifuge to treat the waste water?

The horizontal screw discharging and settling centrifuge (referred to as horizontal screw centrifuge) with a fully closed and continuous operation with a large length-diameter ratio is used as the main machine of the sewage treatment centrifuge, which has the following advantages:

1. Fully closed operation, clean and pollution-free site.

2. The amount of flocculant and cleaning water is small, and the daily operation cost is low.

3. The equipment layout is compact, covers a small area, can significantly reduce the land acquisition and infrastructure investment.

Features :

• All parts coming into contact with the product are made of stainless steel.
• 3-phase AC motor for controlled torque starting via frequency converter
• Approximately 80 to 90 % of the oil is recovered.
• Low personnel costs due to continuous and automatic operation.
• Highest g-force for higher solids output
• Adjustable bowl speed via VFD
• Automatic adjustment of differential speed via VFD
• Two motor drive
• Belts for both primary motor and secondary motor

Installation:

FAQ :

Q:The paper mill sewage is treated with a horizontal screw centrifuge. It is found that there is a little bit more slag and blockage. How to deal with it?

A:How to judge that the horizontal spiral centrifuge has a little more slag? Is it compared with the same technical parameters before? Or did you change another decanter centrifuge or add too much medicine? Increasing the precision of machine parameters or the dosage of reagents both can bring about more slag discharging. In short, the smaller suspended solids that were previously hidden in the sewage are also separated by centrifugation. If the pretreatment is not done well, it can also increase the solid content of the fluid.

We have 2 solutions to solve the condition of more slag. One is to do a good job of pretreatment to reduce the solid content of the fluid, and the other is to adjust the differential speed of the spiral sweeping paddle of the horizontal screw centrifuge to make the pushing more smooth. We use the juneng horizontal spiral centrifuge, which is very stable in performance. After more than two years of use, there is no sudden change in performance.